EPAK2500
Control of Your ES System
The EPAK2500 is a four-way, active control and amplification unit specifically designed for the ES Series modular loudspeaker system. It not only houses all signal processing and four individual amplifiers but also controls the allocation of power depending on the number of bass modules employed. The EPAK2500 is enclosed in a road-rugged case with side handles and a built-in cable storage compartment. Easily transported on a trolley, this unique amplification system has its electronics mounted on an independent suspension system that isolates it from the shocks and impacts typically encountered on the road. A large aluminum heat sink provides passive cooling along with two demand-sensitive fans for added reliability.
Features
4-way modular, 2500W Control and Amplification system for use specifically with ES Series modules
High Frequency, 100W, Class AB, push-pull, low intermodulation amplifier with transformer-balanced outputs
Mid Frequency, 200W, Class AB, push-pull, low intermodulation amplifier with transformer-balanced outputs
Mid Bass, 600W, high efficiency, current enhancing, switching amplifier Subwoofer, 1600W, high efficiency, current enhancing, switching amplifier
Complete on-board speaker management system including equalization, time alignment, crossover filters, amplifier overdrive protection, system set-up, and output level controls
20MHz sampling for onboard time alignment and phase correction
AC soft-start circuitry with ON/OFF AC breaker switch provides thorough power protection
Passive heat dissipation design with demand-sensitive forced cooling back-up system
Set-up provides selection and control of different subwoofer combinations
Professional enclosure using a road-rugged case with side handles
Removable front cover provides storage for all AC and speaker cables
Bass Character- Attack or extension switch alters the low-frequency character
Includes all speaker cables for a single stack ES system -Â CABLE-KIT
Applications
Specifically designed as the amplification and control elements for ES loudspeaker systems
Portable PA
Fixed Installations
Bars and Nightclubs
Houses of worship
High-Frequency Amplifier Specification
Type: Class AB Push-Pull low inter-modulation Mosfet design with transformer-balanced output
Rated Continuous Power: 100W
Distortion: <0.05%
Operating Bandwidth: 2.5kHz to 28kHz
Mid Frequency Amplifier Specification
Type: Class AB Push-Pull low inter-modulation Mosfet design with transformer-balanced output
Rated Continuous Power: 200W
Distortion: <0.05%
Operating Bandwidth: 500Hz to 2.5kHz
Mid Bass Frequency Amplifier Specification
Type: High efficiency, Low frequency, Current-enhancing switch mode
Rated Continuous Power: 600W
Distortion: <0.05%
Operating Bandwidth: 130Hz to 500Hz
Low-Frequency Amplifier Specification
Type: High efficiency, Low frequency, Current-enhancing switch mode
Rated Continuous Power: 1600W
Distortion: <0.05%
Operating Bandwidth: 20Hz to 130Hz
Signal Input
Input Sensitivity: 1.0V RMS
Input Impedance: 20kΩ (balanced)
Speaker Output
Speaker Output: AP6 (Mid-Hi), AP4 (Sub)
Power Requirements
Power Connector: Neutrik PowerCon®
Operating Voltage Range: 100 to 120V@60Hz | 205 to 240V@50Hz | 225 to 260V@50Hz
Recommended Amperage: 20A 115V | 10A 230V | 10A 250V
Physical Dimensions
Height: 719 mm (28.30")
Width: 478 mm (18.82")
Depth: 305 mm (12")
Weight: 32 kg (70.4lbs)
Downloads​​​
Product code
KVV 987 001 - EPAK2500 115V
KVV 987 000 - EPAK2500 230V
KVV 987 134 - EPAK2500 250V